|
Post by lockmaster on Feb 6, 2006 15:29:41 GMT -5
This is another one of my little "brain storms". Arrow holders for your bow range (permanent installation) Per holder: 1 Slip on connector 1 pc. 2" PVC, 16-18" long 1 drain disk 1 Reducer 3 1/2" X 2" Assemble & install as shown & described below: I have three of these (20, 30 & 40 yds) Dig a 3 ft. X 3 ft. X 4-5" deep at your yardage. Sit the arrow holder in the corner, Wide part down, and shovel concrete around the base, then plumb and allow concrete to dry. Then top off entire hole with mulch. (keeps your standing area from getting muddy) Finished "standing area" shown above. Sit holder on the bare ground (no concrete underneath). so they won't fill up with rain water. This makes a great little addition to your bow range.
|
|
|
Post by ScottC on Feb 6, 2006 16:02:06 GMT -5
Pretty sweet set-up. Whenever I get some land I will try that idea.
|
|